Sanwa MX-3X Specifications download pdf (Page 68)

52 Physical Controls

MX3X Reference Guide E-EQ-MX3XRG-H

Endcap Combinations

Left Port Right Port

Serial COM3 Serial COM1

Serial COM3 USB Client

USB Host Serial COM1

USB Host USB Client

Scanner* Serial COM1

Scanner* USB Client

Rear IR Port is COM2

Barcode scanners, tethered to the serial port on a cradle,

send ASCII data to the MX3X in the cradle through the

COM2 Port.

Figure 2-6 Endcap Combinations

* The MX3P does not have an integrated scanner nor an RFID tag reader and antenna.

COM Port Switching

The COM 2 port is always the IR port on the back of the computer, regardless of the type of

endcap installed.

On the Standard Range Scanner / Serial Port endcap COM 3 is the Integrated Scanner port.

On the Dual Serial Port endcap the COM1 port is the serial port on the right side of the endcap

when the display is facing you.

The process used to enable the MX3X COM1 serial port for use with a tethered scanner is as

follows:

Note: Use the scanner control panel to setup using both the integrated laser scanner and a

tethered scanner.

To switch active scanner Com ports select Start | Settings | Control Panel | Scanner | Main tab.

Note: If there is an integrated laser scanner, COM3 is greyed out – if there is no integrated

laser scanner, Internal is greyed out.

To assign baud rate, parity, stop bits and data bits to Com 1, Com 2 or Com3, select Start |

Settings | Control Panel | Scanner | COM .. tab.

See Also: Section titled “Tethered Scanners”.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 315 316

No comments

Sanwa MX-3X Specifications Page 68