Sanwa MX-3X Specifications download pdf (Page 72)

56 Physical Controls

MX3X Reference Guide E-EQ-MX3XRG-H

USB Client Cable

Port Label on Endcap

Mobile Device End Goes To USB Type B Plug End

1 Not Used

2 Not Used

3 D + (Green Wire) 3

4 Not Used

5 Ground (Black Wire) 4

6 Not Used

7 D – (White Wire) 2

8 Not Used

9 Power 1

Figure 2-12 USB Type B to Serial Port Cable Pinout

Connect from USB-H serial port to USB Type B Male receptacle on a USB hub, camera, etc.

Tethered Scanners

Do not connect a tethered scanner cable to a mobile device’s USB-C or USB-H labeled endcap

port. These ports cannot power a tethered scanner. Tethered scanners connect to RS232-labeled

ports on the endcap and can connect to the RS232 port on a powered cradle.

The Scan buttons have no effect on tethered barcode scanners (connected to a serial port).

Tethered scanners read barcode scans only when the trigger on the tethered scanner is pressed. The

tethered scanner requires power on pin 9 of the mobile device’s serial port.

To set the MX3X to use a tethered scanner, select Start | Settings | Control Panel | Scanner |

COM1 (or 2 or 3).

Tap the “Power on Pin 9 (+5V)” checkbox for the COM port selected. The COM port that accepts

the scanner data can be configured for data rate, parity, stop bits and data bits.

See Also: Section titled “Cradles” when using a tethered scanner with a powered cradle.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 315 316

No comments

Sanwa MX-3X Specifications Page 72