Sanwa MX-3X Specifications download pdf (Page 245)

E-EQ-MX3XRG-H MX3X Reference Guide

Chapter 6 AppLock

Introduction

Note: LXE has made the assumption, in this chapter, that the first user to power up a new

mobile device is the system administrator.

LXE’s AppLock is designed to be run on LXE certified Windows CE based devices only. LXE

loads the AppLock program as part of the LXE customer installation process.

Configuration parameters are specified by the AppLock Administrator for the mobile device end-

user. AppLock is password protected by the Administrator.

End-user mode locks the end-user into the configured application or applications. The end user

can still reboot the mobile device and respond to dialog boxes. The administrator-specified

application is automatically launched and runs in full screen mode when the device boots up.

When the mobile device is reset to factory default values, for example after a cold reset, the

Administrator may need to reconfigure the AppLock parameters.

Sections in this chapter that are not specifically Multi-Application or Single Application are

used/changed in the same way by both versions.

Note: To reset the device to factory default values, please refer to Chapter 3 “System

Configuration” section titled “Utilities” and the RegClear, PSMFormat and ColdBoot

executable files.

Setup a New Device

LXE devices with the AppLock feature are shipped to boot in Administration mode with no

default password, thus when the device is first booted, the user has full access to the device and no

password prompt is displayed. After the administrator specifies an application to lock, a password

is assigned and the device is rebooted or the hotkey is pressed, the device switches to end-user

mode.

Briefly, the process to configure a new device is as follows:

1. Insert a fully charged battery and press the Power button.

2. Connect an external power source to the device (if required).

3. Adjust screen display, audio volume and other parameters if desired. Install accessories (e.g.

handstrap, stylus).

4. Tap Start | Settings | Control Panel | Administration icon.

5. Assign an application on the Control (single application) or Application (multiple

application) tab screen.

6. Assign a password on the Security tab screen.

7. Select a view level on the Status tab screen, if desired.

8. Tap OK

9. Press the hotkey sequence to launch AppLock and lock the configured application(s).

10. The device is now in end-user mode.

Note: AppLock cannot support multiple windows of some applications. Attempting to open

multiple windows of RFTerm or Pocket Word will cause AppLock to switch to

administration mode.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 315 316

No comments

Sanwa MX-3X Specifications Page 245