Sanwa MX-3X Specifications download pdf (Page 44)

28 Enter Data

MX3X Reference Guide E-EQ-MX3XRG-H

Using a Headset and Voice for Data Entry

Connecting the Audio Cable and a Headset

Note: The audio option draws power from the main battery. The Headset and Voice option is

not available for an MX3-RFID configuration. The speaker is disabled when a headset is

plugged into the audio jack

The headset consists of an earpiece, a microphone and an attached cable. The headset attaches to

an audio cable which attaches to the MX3X. The audio jack is located on the MX3X endcap.

9000A076CBLHEADSET1

Figure 1-24 Audio Cable and Headset

Insert the 2.5mm barrel end of the connector into the audio jack on the endcap and push the

connector in firmly.

Align the audio cable quick disconnect end and the headset quick connect cable end. Firmly push

the cable ends together until they click and lock in place.

Adjust Microphone and Secure the Cable

Do not twist the microphone boom when adjusting the microphone.

The microphone should be adjusted to be about two finger widths from your mouth.

Make sure the microphone is pointed at your mouth. Note the small “Talk” label near the

mouthpiece. Make sure the Talk label is in front of your mouth.

The microphone cable can be routed over or under clothing.

Under Clothing

• Leave the cable exposed only at the top of the collar.

• Be sure to leave a small loop of cable to allow movement of your head.

Over Clothing

• Use clothing clips to hold the cable close to your body.

• Tuck the cable under the belt, but leave a small loop where it goes under the belt.

• Do not wear the cable on the front of your body. It may get in your way or get caught on

protruding objects.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 315 316

No comments

Sanwa MX-3X Specifications Page 44