Sanwa MX-3X Specifications download pdf (Page 54)

38 Docking Cradles

MX3X Reference Guide E-EQ-MX3XRG-H

Desktop Cradle

Note: LXE recommends the correct Desktop Cradle always be used to store / charge /

communicate with the MX3X. The MX3X Desktop Cradle label is located on the bottom

of the device. The MX3X Desktop cradle Product Number is

MX3RA002DESKCRADLE.

Lower the mobile device straight into the cradle, tilt it forward and then let it rest backward in the

cradle. Ensure that the mobile device is properly seated on the charging contacts. The CHGR LED

will illuminate green when the MX3X is correctly seated in the cradle. The CHGR LED will

illuminate red when the MX3X main battery is being charged (in a cradle connected to an external

power source). To remove the MX3X, tilt the MX3X forward and lift it straight up out of the

cradle.

Note: Do not “slam” or slide the mobile device sideways into the cradle. Damage may result.

The MX3-RFID and MX3P devices do not fit in the MX3 desktop cradle.

Connectors

The Power connector is located on the back of the cradle in the top left hand corner. The cradle

can be powered, if required, by an LXE US AC Adapter or an LXE International AC Adapter.

When powered, the cradle transfers power to the internal charging circuitry of the MX3X allowing

it to recharge the main battery. A powered cradle supports RS-232 and IR communications.

The RS-232 connector is located in the back center of the cradle. When the MX3X is properly

docked, the bi-directional half-duplex transceivers in the MX3X and cradle are aligned through

their IR windows. The half-duplex IR signals from the MX3X are converted to RS-232 signals in

the cradle and available at this connector.

Vehicle Mount Cradle

This cradle is specifically designed for vehicle mount applications. The cradle restrains the MX3X

and isolates the mobile device from shock and vibration. The MX3X is inserted into the cradle by

placing the base of the unit in the pocket and then firmly pressing the unit backwards until the

release mechanisms latch and hold the unit in the cradle. The MX3X is removed from the cradle

by pressing the release mechanisms and pulling the MX3X up and away from the cradle.

Connectors

The Power connector is located on the back of the cradle below and to the left of the RS232 port.

The cradle is powered by either a vehicle’s 12V battery or from an approved accessory for

vehicles with higher voltage (24 to 60 VDC) batteries. When powered, the cradle transfers

external power to the MX3X, which in turn, recharges the main battery. A powered cradle allows

RS-232 and IR communication.

The RS-232 connector is located on the back of the cradle below and to the right of the power

connector. When the MX3X is properly docked, the bi-directional half-duplex transceivers in the

MX3X and cradle are aligned through their IR windows. The half-duplex IR signals from the

MX3X are converted to RS-232 signals in the cradle and available at this connector.

Note: ActiveSync will transfer files over the RS-232 connector on the vehicle cradle.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 315 316

No comments

Sanwa MX-3X Specifications Page 54